In April and early May, at long last, the Mitchell House roof was replaced. (I noted this in an earlier blog.) I had also noted that the roofwalk, given the condition it was in and its location – sitting on the ridge – had to be replaced. They had thought they could jack it up – as they have done with other walks – but the Blizzard of February 2026 that was ALL wind (83 MPH winds – read Category 1 Hurricane) and no real snow, made the walk impossible to treat in such a manner (read: crumble).

So, after much discussion, review by our preservation easement holder, and permits, as well as some fundraising, we are replacing the roofwalk. The prior walk was not the original. The original blew off in a gale in the late nineteenth century, replaced at some point in the 1930s, and likely replaced again in the 1960s or 1970s. Then, since that time, it was heavily repaired. Its framing members were notched to accept the ridge boards (read: peak) of the roof and I think that may have been an original way to construct a walk. Makes perfect sense – and gives the walk more support and a lower profile. It was after all about putting out chimney fires and preventing roof fires. People copied what worked – and there have been a few others noted to be built in this manner still. It presents an issue though – because if you need to work on the ridge board or close to it – you cannot get to it easily – I guess you may be able to access it to some extent by lifting the deck boards of the walk. The new Mitchell House roofwalk will sit about six inches above the ridge – which will also allow air to circulate better over the ridge and the shakes in that area. That is the only thing that will really be different. It is protected by a preservation easement – as part of the Mitchell House’s easement – and frankly, even if we did not have an easement, we would not want it to look any different.

So keep your eyes to the skies at 1 Vestal as we work to re-build the walk. With a special thank you to Barber and Sons and Lydon and Sons.

JNLF